1. Take two Only Eveready Company Plastic Torches.
a. Battery in those torches should be of Eveready Company wrapped in white colour paper body, which is 950 model made. Batteries body shouldn’t be steel body.
b. Remove the glass in front of torch.
c. Switch on the torch bulb.
d. Once the bulb filament is cut, leave it for 10 minutes.
e. Never switch off the torch.
f. Now, leave the bulb to be cold for 10-12 minutes.
g. Now fold both torches by paper.
h. Then pack each torch by condom from both sides.
2. Take 2 pieces of plastic electronic watches.
a. In the back side of watch remove either steel body or plastic body whatever.
b. Keep these watches on the article (RP) for 10 minutes mandatorily at least, even though it stops working in less than 10 minutes.
c. Now, leave the watch to be cold for 10-12 minutes.
d. Now fold the both watches by paper.
e. Then pack each watch by condom from both sides.
3. Take a camera film of 450mm.
a. Be in a dark room. There shouldn’t be any light in the room.
b. Open the film roll. Take one side of one end of the roll.
c. Bring the roll near to the article.
d. It will flash and fuse the roll and make a mark on it.
e. Repeat this process for 3 times which will result into having 3 fused spots each 6 inches apart on the roll.
f. Now take other end and also other side of the roll.
g. Bring the roll near to the article.
h. It will flash and fuse the roll and get a mark on it.
i. Repeat this process for 3 times which will result into having 3 fused spots each 6 inches apart on the roll.
4. Now bring these samples safely with your id proof and residence proof of yourself for the agreement with our company.
5. Once your samples will be ok and agreement will be done with Co. the payment process will be started next day onwards.
6. We will collect the article later from your place after all payment will be done.

Thnaks
Sandy
8130260404